I also noticed that this way there aren’t so many fumes going into your nose since you can ( and you should! ) keep your head away. Those times when you had to be looking at the components closely and inhaling the fumes are over. As soon as I started, I learned a valuable lesson: first desolder all the connectors or they will melt while you try to remove other components. I learned it the hard way :x. However, in general it’s pretty easy to desolder using the hot air gun. Just point the gun at the terminals for some seconds, then grab the component with some pliers and pull it.
Hi again! If you are like me, sometimes you take electronic devices home just to tear them apart and scavenge some electronic components or some dc/stepper motors. It’s always a great way to learn about electronics and to save some money. Sometimes you get to know some new IC… sometimes you get some really expensive IC… sometimes you get an IC that you couldn’t even buy if you wanted just one or two… So, my advice for you if you like to make some circuits for fun is to start scavenging all the electronic devices that your friends and family throw away.
Until today I always desoldered the components with a desoldering iron and a desoldering pump but that’s really slow, really tiring and sometimes it’s also very annoying when you want to remove some component that just won’t come out of the board or gets its legs ripped apart after 5 minutes of heating, pushing and pulling. Removing conectors or ICs with lots of pins is always very hard too. And the worst part.. it’s not good for your health since it releases lots of dangerous fumes. But now I use a new technique! 😀
Last week I saw a webpage from pcbheaven describing a way of salvaging every kind of electronic components in a very fast and efficient way: using an hot air gun! The video on the webpage I referred convinced me, so today I went to the hardware store and bought the low cost 2000W BT-HA 2000 Einhell Hot Air Gun which goes from 350ºC to 550ºC. It costs about 25€. When I arrived home I began experimenting with it and it worked exactly as desired :D. I am now a fan of hot air desoldering :P. In about an hour and half I desoldered all the components shown in one of the pictures. I could have removed much more components but I only removed the ones that maybe I could use.
Try not to burn yourself. As security you can and should use protective gloves and glasses.
Oh, and last but not least, don’t forget to dispose the remaining components and PCBs properly!
Did you find this post helpful? Do you wish to contribute to other projects regarding computer science, electronics, robotics or mechatronics that will be posted in this blog? If you wish to do so, you can donate via paypal using the button below. Thanks! 🙂